|
Small Boat Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
|
|
Small Boat Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
In Reply to: Re: getting a used engine to run right posted by fishindude on July 24, 2004 at 20:01:32:
Smoke from a two cycle always means too much oil in the mixture or the carburator is running too rich. The fuel goes into the crankcase of a two cycle engine before going up through the ports in the cylinder walls to be ignighted. The oil in the fuel lubricates all the moving parts including the crank and rod bearings. Poor or worn rings just means less compression in the cylinder and vacuum in the crankcase. Lean the carburator out but first get the mixture right for the motor.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: getting a used engine to run right - Loweboy 17:58:17 07/29/04 (1)
- Re: getting a used engine to run right - papasage 17:14:26 08/22/04 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
